Not sure how to fix another 13.20 error on the HP 9000 Laserjet printer? It’s actually not a very complicated process. Most people who ask how to fix persistent error 13.20 on the HP LaserJet 9000 printer receive this message about jams in the area coming from the top cover of the printer. This disease occurs at least 1-2 times when using the device. For now, this is not a big inconvenience to worry about, as it can be fixed on this page without spending much time and patience.

How do I fix my printer error code?

You can try restarting the printer first. Turn off the laser printer, then unplug the power cord. Reconnect the printer and turn it on. Resetting a specific printer is an easy fix, although for some people it’s still enough to fix the problem.

If you’re probably wondering how to fix one error 13.20 on a Hewlett Packard 9000 LaserJet printer, keep in mind that thisa dangerous error occurs whenever an incompatible curing unit is normally installed or the sensor is blocked. The main causes of this problem are paper jams or even a bad pickup roller exit cover, jams in printer teeth whitening trays, and more.

Here Are The Most Important Basic Steps To Follow In Particular:

How do I clear the error code on my HP printer?

With the printer turned on, disconnectNew printer power cable.For now, unplug the power cord from the shock source.Wait 60 seconds.Plug the power cord back into the outlet and into our printer. Note. HP recommends connecting this printer directly to a side electrical outlet.

  • Check the machine for a paper jam. You must first remove any torn pieces or pieces of newspaper if they are obstructing all of the paper inside the printer. You can also check for jams by looking for the prefeed sensor, and if the specified slot is not working properly, you can move on to the next one.
  • Remove the specified paper tray from the HP product, and use the removed toner cartridge.
  • Maybe you should check if there is any community without a paper width sensor. If movement is restricted, the person should receive the same adjustment. case
  • If you have replaced the paper feed unit, you need to make sure that the feed sensor indicator thatYou see, it is moving correctly. Sensor technologies can be viewed at the top of the page for the respective sensor. If necessary, check whether the prefeed sensor is properly equipped.
  • First, you need to isolate the backup and see if there is a jam. If the paper is jammed, remove it carefully and completely.
  • You can replace the PCA of the DC controller, which can lead to recovery problems.
  • After that, you need to remove the cartridge and toner cartridge and pull out the paper tray until you get paper width paper. This can serve to continually slip past the reels to renegotiate conditions. A piece of cardboard should be inserted into the slots of the device and stop on its own, when you access it, you will see a cavity at the top.
  • Carton is carefully removed from the notched cavity at the end of the printer instructions, while the paper tray and mouthpiece must be returned to their places.
  • The printer manufacturer needs to be restarted again and the above steps will also help someone decidethis problem without any problem.